09/02/10 00:49:28 X+QJpWYj
>>53>>60 dmesgの結果です。それっぽいところを抜き出してみました。
libata version 3.00 loaded.
sata_sil 0000:00:10.0: version 2.3
ACPI: PCI Interrupt 0000:00:10.0[A] -> GSI 18 (level, low) -> IRQ 16
scsi0 : sata_sil
scsi1 : sata_sil
ata1: SATA max UDMA/100 mmio m512@0xe3021000 tf 0xe3021080 irq 16
ata2: SATA max UDMA/100 mmio m512@0xe3021000 tf 0xe30210c0 irq 16
ata1: SATA link down (SStatus 0 SControl 310)
ata2: SATA link up 1.5 Gbps (SStatus 113 SControl 310)
ata2.00: ATA-8: WDC WD10EADS-00L5B1, 01.01A01, max UDMA/133
ata2.00: 1953525168 sectors, multi 16: LBA48 NCQ (depth 0/32)
ata2.00: configured for UDMA/100
scsi 1:0:0:0: Direct-Access ATA WDC WD10EADS-00L 01.0 PQ: 0 ANSI: 5
sd 1:0:0:0: [sda] 1953525168 512-byte hardware sectors (1000205 MB)
sd 1:0:0:0: [sda] Write Protect is off
sd 1:0:0:0: [sda] Mode Sense: 00 3a 00 00
sd 1:0:0:0: [sda] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
sd 1:0:0:0: [sda] 1953525168 512-byte hardware sectors (1000205 MB)
sd 1:0:0:0: [sda] Write Protect is off
sd 1:0:0:0: [sda] Mode Sense: 00 3a 00 00
sd 1:0:0:0: [sda] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
sda: sda1 sda2 sda3 sda4 < sda5 sda6 sda7 >
sd 1:0:0:0: [sda] Attached SCSI disk
sd 1:0:0:0: Attached scsi generic sg0 type 0
NCR53c406a: no available ports found
scsi: <fdomain> Detection failed (no card)
GDT-HA: Storage RAID Controller Driver. Version: 3.05
SATA_SILはあるみたいです。